Hello Forum,
I use an U2001A power meter on a N9320B analyzer. I can configure the analyzer with :conf:pow to switch in power meter mode, but how can I read results?
Hi Keifra,没有SCPI命令来读取N9320B中的功率计测量结果。
或者,要在PC中读取结果,可以使用N1918A功率分析管理器在PC上读取结果。
它允许您直接将功率计连接到PC。
N1918A电源分析管理器http://www.home.agilent.com/agilent/software.jspx?ckey=sw258&lc=eng&cc=HK&nid=-35560.695945&id=sw258最诚挚的问候西蒙
以上来自于谷歌翻译
以下为原文
Hi Keifra,
There is not a SCPI command to read the power meter measurement result in N9320B.
Alternatively, to read the result in PC, you can use the N1918A power analysis manager to read the result on PC. It allows you connect the power meter to PC directly.
N1918A Power Analysis Manager
http://www.home.agilent.com/agilent/software.jspx?ckey=sw258&lc=eng&cc=HK&nid=-35560.695945&id=sw258